Recent content by fluffypenguin

The gauge of the wire shouldn't be the problem, since the usb lines are data with very low current going through them. For the twisting, using a drill and twisting until it breaks off is the recommended method. Here is an example from YveltalGriffin on the discord for how it should look: If it...

Sweet case! A few things to check: The VGA option needs to be enabled in the RVLoader installer. If you didn't do that, you need to re-run the installer. Make sure that the MODE pin is connected to 3.3v, if it isn't VGA will not display. It's hard to tell in the photos if it is connected...

It measures 220x95mm with a thickness of 27mm in the middle, and 37mm at the grips. The HDMI comes from the ElectronAnalog from Electron Shepherd, and there is also VGA switch from there that cuts the video to the screen when the HDMI cable is plugged in, using the HPD signal.

Someone in the 4LayerTech Discord server found a fix, and it has worked for me. The pinout for the headphone jack was slightly off on the U-Amp/RVL-Amp and the Ashida interface board, with the HR and GND pins being swapped. Changing those pins makes the audio equal in both sides.

Your best bet would be trying RiivolutionIsoBuilder, although compatibility will not be 100%.

Cherrii After many failed 3d prints, shoulder button iterations, late night soldering sessions, and VGA debugging, I have finally finished my first wii portable. The main goal was to create a portable that was somewhat compact, while still maintaining full size gamecube buttons, plently of...

Hello everyone! It has been a long time without a post, but a lot of progress has been made on the project! It is currently in a playable state (after replacing a fried PMS), with just a few more bugs to iron out before I can consider it done, but fixing that might take a bit since I have gotten...

I have been experiencing the exact same thing with an unmodified U-Amp from 4layertech in a Wii portable. For me, the music is on the right, and the sound effects are on the left. I haven't tested mono audio, but I'm guessing that it would be the same situation with the right being twice as...

I've learned a lot from this playlist of guides from Dubesinhower

The case is 220mm*95mm for the length and width, and the depth is around 25mm in the middle and around 35mm at the grips

First set of test prints completed! The color is a bit different than expected, but it still looks nice Good News: The face buttons and dpad fit and feel nice The joycon sticks fit and have their full range of movement Rumble motors fit nicely All of the ports (USB, HDMI, headphone jack) fit...

After researching and learrning cad over the past few months, I think I am ready to start a worklog for the wii portable I've been working on. It is nicknamed the Cherrii because I got a spool of nice dark cherry red PLA that I would like to print it in. Features: OMGWTF trim Full size...

Hello, I've been lurking and researching here for a little bit, planning on designing and building a Wii portable.