cy

Hey guys what's up! Sorry this is kind of a direct copy and paste of blog post but I felt there should be a post here about this...

I just remembered that I went with those heatsink because of stuff I read years ago. Here's a good chunk of info on that...

That's definitely on the hot side. I solder at 327C or 622F which is quite a bit lower. I've got a guide on Wii micro soldering that...

Wee Wii Hello all, some of you may have seen me post about this in the discord a while back, but I am now finally getting around to...

success to boot

Holy moly that's impressive! When you say success to boot, do you mean you've already tested and it works? Is that CCTV device taking...

Dang, that's a rip on the N64 board. At least you know what it was! That's good to know about your cooling setup! I've been...

Thanks for the feedback! I haven't measured the exact thermals, but I stressed it for many hours and haven't had any issues. I...

I actually started working on that over 10 years ago, but my electronics knowledge was basically inexistant and it feel apart quickly...

I don't mean to necro bump here, but I found this thread while I was looking through worklogs trying to get more information on how...

You don't need the U10 component as the PMS2 has a U10 pad you can solder to that replaces the need for a U10 relocation. There are...

This model is to scale and can be used for whatever it might help you with! The measurements should all be good as I cross-referenced...

Printed this Wii Miicro shell a while back but ended up not using it for a build. Asking $25+shipping, will come with button/psu-plus...

i have been trimming this dreamcast motherboard over the past few days and now that ive done most of the relocations and its worked so...

Looking at the Dreamcast trimming guide, it looks like you removed the correct regulators. The guide tells you what voltages you need...