Solved Preparing for trim

[Proxamity]

Thanks so much, this community is super helpful!

That's the point of Bitbuilt

 

[Toaster912]

https://bitbuilt.net/forums/index.php?threads/gc-documentation.695/
Don't cut a gc controller, the whole point of gc+ is so you don't have to

So what your saying is if I buy the GC+ board I can solder the buttons to the controller board and it would work? I'm a bit confused.

 

[Noah]

GC+ is a complete controller replacement. The board in the picture IS the GameCube controller.

 

[Ikeprodigy]

So what your saying is if I buy the GC+ board I can solder the buttons to the controller board and it would work? I'm a bit confused.

The GC+ board is basically an original GameCube controller chip. It makes it easier to relocate the controller because it has places you can solder to rather than the chip legs.

 

[Aurelio]

The GC+ board is basically an original GameCube controller chip. It makes it easier to relocate the controller because it has places you can solder to rather than the chip legs.

No, it isn't. It's not an original GameCube controller chip. It uses a microcontroller with a firmware I made specifically to work as a GameCube controller with some extra features

 

[Ikeprodigy]

No, it isn't. It's not an original GameCube controller chip. It uses a microcontroller with a firmware I made specifically to work as a GameCube controller with some extra features

This is what I meant. Lol! I was trying to explain it how I understood it but I know what you mean.