- Joined
- Oct 25, 2022
- Messages
- 10
- Likes
- 0
Currently my ps2 portable is using 2s 7.5v but it will cut off on 7v dose anyone know how to make scph 90006 will go around 6volt or lower if can.
Did you know how to mod it to have lower cut off voltage?In my experience, a 9000x motherboard with 2 18650 batteries, 3400ma, can operate for 1.5 hours, and the shutdown voltage is 6.5-6.9v, which can actually have deviations.
To expand on this: Most protection PCB/BMS listings will have the low voltage cutoff written somewhere in the product blurb. Whether the figure is accurate depends on the seller, but it's usually a good indicatorIf you are using a BMS it is actually probably that cutting off at 7.0v instead of the PS2. I had a similar problem with a cheap BMS I ordered that was designed to cut off a little early (not a bad thing in terms of safety) but I found a different one that would let me go to 6.8v instead. Cant remember which one it was or I'd link it for ya.