Hey there! I'm finally getting around to putting together the G-boy and am a little worried I trimmed the Wii board too far.
In the attached image, the red outline shows the OMGWTF trim with the blue line showing what I did on the top side.
I went straight through the center of the 3 "DA_" components circled in pink. The G-boy trim is very similar/ slightly different than this, but I noticed that these 3 components are still intact in later steps of the G-boy guide. Nothing appears to get wired to them directly so I'm uncertain whether they are used or needed in any capacity.
Am I still okay to proceed or do I need a new Wii board? Thanks in advance for any advice!
In the attached image, the red outline shows the OMGWTF trim with the blue line showing what I did on the top side.
I went straight through the center of the 3 "DA_" components circled in pink. The G-boy trim is very similar/ slightly different than this, but I noticed that these 3 components are still intact in later steps of the G-boy guide. Nothing appears to get wired to them directly so I'm uncertain whether they are used or needed in any capacity.
Am I still okay to proceed or do I need a new Wii board? Thanks in advance for any advice!