Discussion Finally Finishing My Ashida

[Bunnizer]

It’s been 3 years since I first found out about portablizing consoles and in that time I have learned a lot about general electronics as well. I now feel ready to finish up my Ashida that I started years ago. I have just ordered the rest of the parts that I hadn’t ordered yet. I now feel confident and comfortable enough to solder and relocate both the bluetooth/mx chip, but I don’t know how it will fit in the case. Are there mounts in the case? Or will I have to just find somewhere it fits? This should be the final question unless I have some troubleshooting issues. Any help is greatly appreciated

 

[JamesPi]

There aren't any mounts unless you get a relocation flex, so just Kapton tape it where there's room and where there shouldn't be interference. Good luck finishing it, I can't wait to see the final build!

 

[Joodies]

It’s been 3 years since I first found out about portablizing consoles and in that time I have learned a lot about general electronics as well. I now feel ready to finish up my Ashida that I started years ago. I have just ordered the rest of the parts that I hadn’t ordered yet. I now feel confident and comfortable enough to solder and relocate both the bluetooth/mx chip, but I don’t know how it will fit in the case. Are there mounts in the case? Or will I have to just find somewhere it fits? This should be the final question unless I have some troubleshooting issues. Any help is greatly appreciated

There is a lot of unused space above the u amp right where the unused screw post where you can mount the Bluetooth module. That’s what I did.