Search results

Are aftermarket iron tips any good i got this set for my hakko fx888dx and there's a noticeable difference especially with length the top tip is the original one and the 1 below it is the aftermarket one question is are they any good or should get a actual hakko tips im curious if anyone...

PM'd!

I see some spots on the right side and bottom side that seems like there's no connections to the pads do a touch up with your soldering iron with a good tip and use some flux Touch up on all the sides just to make sure they're connected

Did you wire it up right?

I see one of the pins on the front row and back as well has no connection to it maybe that's it That's the only thing I can see

Check your resistors/capacitor for short one of them might have went out

Did you test it after you trimmed it And the traces that was cut off does it go to anything on the other side of the board?

Im looking for someone if it's even possible to 3D print this parts it's for a grinder i've looked online and can't even find the right one that matches it and i need about 30pc ill ship off the one i have to whoever can do it so they'll have a good view of what they're working with i hope...

https://wololo.net/2021/12/07/madlad-cuts-motherboard-in-half-to-create-portable-sega-saturn-and-it-works/ Look at what i found today Anybody else goes to this site?

Its beautiful! i need to start getting into portablizing

I have 2 of the same ones on the left and 5 of the same ones on the right

I have about 4 or 5 of them I'll check it out when I get home

Nice and how can one get video input? Is it possible to get composite or will we have to use a ultra vga for that

Really i haven't seen anyone do it on a later revs I know about the earlier revs

You'll need a different revision of the n64 board if you want to trim it that small

What a beauty :D

did you have to cut a piece of the back cover to get the battery to fit? and what pin goes to what on the sd card reader?

N64PMS will let you charged and play

It should've worked just try solder two wires onto the tactics switch 1 to the reset pin and 1 to ground