Search results

Ya I know its going to be a pain in the ass that's for sure but maybe I could do the straight lines for the power lines and the rest could be ground? Thoughts on that?

I found this pinout and if this is the case it may be hard to allocate them next to each other like that? maybe I should mark one side so I know which way needs to be up and which down

Ok cool, I think i can do that, just ordered the port as well as 10 test cords to mess with... Now I wait

Found this tagged in a trailer while working last night figured this would be the right place for it :D Is this your drawing shockslayer?

Do you mean two total, one ground one power or two to each of those?

There's 8 total pins what if I connect a few? Or still not going to work?

What if I take an iPhone charging port and connect two pins to the wall charge part of your diagram and two pins to the other side? Do you think that would that work or no?

How would you suggest I do this 4 pin plug or where can I find one?

That makes sense, I'm just trying to get the slimmest profile with the least amount of things in a case is all. I've got the 7.4v batteries and the custom regulators already. Any recommendations on a small charge port? And is this what you mean by before the switch? would it be this port or the...

Probably a silly question but is there a way you can have one smallish port for both charging and wall plug and play instead of two separate ports? Or could you just leave off the wall plug on the bottom right pin of the DPDT switch if you wanted to...

So I recently purchased a 7.4v Batterypack split it in half to get two slimmer portions, but my question is are these already equip with the protection board(s) or what are those boards on top of each for?

Wired up my Ti regulators and tested their outputs with a multimeter, I got the following voltages: 5.05v, 3.38v, 1v, and the last jumps between 1.15 and 1.16. Just wondering if these slight increased voltages are to above what they should be and if I should redo them or if they will be fine?

Does the signal/data pin running off the GameCube controller need to be shielded or will a non shielded wire work fine?

That's kind of what I figured but I just wanted to make sure before I wired it up and tested it out. Thanks.

On the TI regulators do you have to wire ground and power wires to the top pads or can you wire them to the bottom pegs of the board?

Did you use controller pads for both abxy and d-pad buttons? And from which controller did they come from

Also what are some good websites to download cover art for n64 games in .png format, I've found when using .jpg on some games it does not work correctly when loading the emulator shortcut and glitch out or freezes?

It's that simple? seems doable.

Choice between cursor type/color when downloading the pack? maybe the pointer finger red or blue

When you land your first official job