Search results

Has anyone ever seen those original 1st party sticks made from tefla material? I was gonna look into it to see when they'd be available so I can refurbish a controller that I have for smash 64 and whatever else I decide to pick up again. Maybe someone here could consider trying one for a...

What kind if abxy and dpad buttons are those? Looks nice

Not sure if it well ever be of any use, but ran into this video on YouTube of someone restoring an old GBC felt like these methods could be useful and could add more videos like these if it's ok

I dont think anyones had issues with post loader in any way shape or form. I'd listen to them.

Any standard pencil tip iron should be fine, looks like that ones bigger than most I've seen You should invest in a good hot air station and ditch standard irons. I'm not sure about the homebrew channel though. Theres isnt a need to use it after fully installing PM as you have all the HB...

Just a couple of small nicks on the front that I'm trying to get rid of, but im managing to get the back half on par. However I got quite a bit of sanding to do around the r and l button holes. The plastic printed a little iffy on that, but Its not too bad, one thing that got my attention was...

He doesnt use these forums as far as I know He might still be on modretro. I've gotten a 3ds slider converter from him and a programmed pic chip for the 64 controller However from my experience of talking to him he can be a little mean. He refuses to teach how to program ics or anything I'd...

I'm pretty sure he gets his pcbs from rdc

Oh ok. I didn't see any resistors on your board so I had to ask You're advances in knowledge is making Nintendo look bad lol MGC sounds badass I'd like to go to one sometime

Depending on the board revision does this sort of relocation still require the 2k resistor?

N64s are weird and sensitive from my experience with messing with them. Keep a close eye on it fingers crossed for you bro.

I like that one lol

If you tin your wires and the pins you don't need any extra solder, It makes wiring a lot easier, just keep the wire stripped at like 2mm and keep your tip clean. Also, you could also use a desoldering iron to pull the pins out from the back of the board so you can actually solder into the vias...

"Naked Snake" Portrait done with India ink, a micron pen and Graphite on Strathmore paper. 8X10" Prints available for 10 dollars plus shipping.

so id just like to say that you were right. i redid the whole cart slot relocation, I was shooting to have the wire out 3in long, but I'm a little clumsy and had to shorten the wire along the way so its around 2-2.5in lol anyway, its working, does anyone know what capacitor was used on the video...

I'm considering on just redoing the whole relocation. If I used 26awg would 3 in be reasonable? I was thinking of seeing if I could have the motherboard sit on the cartridges. However it could probably be done the way it is? Either way I'm gonna test the gnd and 3.3v leads with 26awg wire.

What's that board sitting on the heatsinks?? Is it for better video?

I might have already read this somewhere, but you can perform the u10 relocation without trimming the board? I thought u5 was needed for running the Wii with the onboard regs

Hang in there man, we seem to be in a similar situation. But I definitely had the same thought about the difficulty lol..