Search results

Once again. Please do not double post. Use the edit button

Please do not double post, and please do not reply to threads unless you have something constructive to contribute to the discussion. If you are going to offer criticism of a project, at least make sure it is a thought out response.

Unfortunately, I think its unlikely members on this forum will be familiar with Devolution. The Bitbuilt and the Wii modding scene kicked into gear shortly after Nintendon't became a viable alternative. The few of us around before BB, Nintendont and the Wii portablizing revolution went straight...

It gets even worse with four

>On 4 wiis >Using dolphin These 2 statements are not compatible. Dolphin is an emulator that runs on computers and other devices. The wii does not run dolphin or emulate GameCube games. The person in the video was not running them on Wiis. Try running more than 2 wiis. Every one you add, the...

1- You could use either, but 4 layer boards would obviously be better. 2 - about 8.5 watts for 6 layer, about 5 watts for trimmed 4 layer. 3 - A single PTH regulator is not powerful enough to run more than one 4 layer wii. I suspect it cannot power a single 6 layer wii due to how much more...

Looking great so far. Is there any technical reason why nobody has made a small rambus termination flex pcb? I've been wondering about a Terminator 64 for years.

Highly unlikely your AVE is fried. If it wont boot without priiloader reset to ground, its likely a wiring issue. I suspect USB. Your method of "twisting wire" by having one wire wrapped around the other is not correct at all. For USB, both lines should be the same gauge, as close to the same...

I wonder if it's a power draw thing. The everdrive draws a lot more power than a regular cartridge. How much is your pms battery charged? Maybe try throwing 2 cells (of the same charge level) into it rather than one, and/or fully charging them.

I have no N64 trimming experience, but the first BitBuilt diagram says to connect everything except 24 and 49. I suspect this also includes 13 and 38 as well?

Did you connect every pin as stated in the guide? It's hard to tell from the photo, but it looks like several pins do not have wires connected. Also note the everdrive specific pin in Drownings pinout

mGC Nano

I suspect its a power issue. Run thicker wires for the power and ground running to the cart slot

I've been thinking about this one for a while, but I don't play on rectangles so I never had the interest. Glad someone is finally doing it. If you use a PMS you could add batteries and make it completely portable. You could also integrate a composite screen onto the box itself and still have...

These carrier boards that solder directly to the Wii are quite cool. You could add PMS 2 compatibility by using our castellated module footprint. Then community members could solder the PMS 2 or PMS lite directly onto your carrier board, adding full second generation PMS functionality onto your...

I personally do not want you to disappear from the community. You seem very skilled, and knowledgeable. I feel like you have much to offer and contribute. Your PS2 case is very cool and very creative. We want you to make and sell your own new and creative products that you designed. Selling the...

So let's put aside the fact that you are using designs open sourced by the community members to compete with said community members, with no improvements or contributions. While the license does not prohibit it, it certainly isn't in the spirit of open source. You also seemed to feel the need...

We are working on it :D

It is