Search results

Now Planning on how to fit in the front case... (That's the PS1 Screen... which is I'm not going to use. I'm just using it to visualize what will be the final output of the front case)

lmao. hahaha :facepalm: but why does it says HDMI?

HOLY MACKEREL! I never thought that my 1st motherboard is still alive (The one that is frustrating to power back then, now looking at it, it's well alive & kickin' B|) So what I did, I just re trim it with dremel, since what I used back then was a diagonal cutting plier, then finally sand it.

ok show me the other side of the board part :)

how bout the reset switch?

I have successfully trimmed my motherboard! :) I realized that when I plug, as usual, the red light will appear indicating that there's a power on the motherboard, but when I press the switch, the green light does not appear anymore, and when I hold press it to turn it off, it goes back to...

Here's a clearer picture btw, this is my first motherboard, the one that is frustrating to power up back then

nope, i started on 600 directly

600 grit, as Gman told me

So I cutted my first motherboard, so after sanding it, the sides look dark, and there's a thin horizontal line of the color of the copper near the edge of the motherboard, is that fine? will it cause shorts? it's just like this

what should the sides physically look like after I trim? what should the sides physically look like after I sand paper? (The picture above is my first PS2 Motherboard, the one that is frustrating back then to power on, i cutted it using a cutting plier back in december 2013) And I'm...

I saw your custom controller, it kinda resembles my controller (the one in this picture) I see Ashen's controller back then that he added a resistor to a PS2 controller did you add a resistor on your controller? since our controller is almost identical

Is this what you mean? where is the ground on the 1st picture? can you point it to me?

Nvm It. I need help. How do I wire the SELECT, START & ANALOG Buttons to the PCB? Edit this picture using paint. I really need help

sorry, i'm not gonna invest for a hot air tool, that's too much, i'm only doing this as a hobby and not too much expenses for unnecessary things

i hate it when soldering irons are disposable, the needle point of the soldering iron does not stick anymore and only gives frustration

is it fine if it's all bulk up in P- ?

So I followed this diagram Is it the same just like how I did in the negative (-) of Charger Port, negative (-) of AC Adapter & the ground to PS2 Motherboard?

Am I doing it right for my analog? this is where I cut this is where I re wire it

Looks like I found how to have a VGA output for PS2 Do you think this will work?