Search results

Can you drill the ground points on the Wii motherboard in order to fit a bigger screw/ mount? Just slightly not remove entirely

thanks guys, I’ve got some 22 awg wire on the way I’m going to use instead, I’ll keep y’all updated

Ok Just checked the C9, it shows 18.85 mega ohms. What else do you think could be causing the problem? By the way, thank you and thanks Mr Cheese for helping me rn

Found it and here’s a picture

I’m not 100% sure, but I know It’s wire I took from a power cable that can carry 12v to power a screen

Where on the board is C9? I bought this one already assembled

Yes! Ok so progress, when I disconnect the 3.3v cable, the 1.5v and 1.0v are outputting the correct voltage. So the wiipms stays on when only connecting 1v and 1.15v. So this means something is wrong with when I connect the pms to the 3.3v? Any ideas?

Panasonic HIXON NCR18650B 3.7V 3400mAh 18650 Battery Lipo Rechargeable Batteries)

The resistance was measured without the pms connected And the voltage turns off for all WiiPMS regulators yes (even the ones not connected) But when the wiipms isn’t connected to the Wii, it reads fine cleaning up that spot your mentioned rn

Ok so I’ve been in contact with Gman about this and I wanted to see if anyone else could assist, the wiipms board is 100% working properly. However, when I connect it to the Wii motherboard, the voltage shows up but quickly shuts back off (probably because of a short somewhere). I know it may be...

Here’s a pic

Ok I have a problem, I check the voltages: 5v outputs 5v 3.3v outputs 3.3v 1.5v outputs 1.5v Here’s the problem: 1v outputs 3v?? 1.15v outputs 3v???

thanks! You’re a legend :D

Ok, please someone/anyone check my wiring, I literally can not afford to buy another WiiPms XD If I connect the battery to the board and power the screen separately, will it work or will it explode? check it: (The magnet wire is connected to the gpu pin on the back)

Thank you :D Everyone on this site is so helpful!

What gauge wire should be used for the 3 Wii operating voltages? 5.5v seems to be the most, thanks

Just Spray painted it, eh idk how I feel about it but I think that I need to accept it XD what do y’all think?

I’m probably just going to order another pms, but I need to figure out what caused it before I do it again, do y’all think it could’ve been from reversed positive and negative from the battery? I’m thinking I read the pin out wrong for the power switch

I was thinking Gman could help out with this question, but smoke just came out of the wiipms, what should I do? I undid the power switch and used alligator cables, it appears to work fine but what the hell went wrong?

Update 11/10/19 Got the face buttons figured out, it was very complicated tbh, it looks very redneck-ish but check it out!