Recent content by Lemoncake

Okay, so I don't think the size of the WAD is going to change much (unless it's a good 10 mb bigger). I wasn't able to track down the OoT Debug WAD, but turns out Ogre Battle 64: Person of Lordly Caliber (?) was a little less than 1 mb bigger, and the injection still returned with a "ROM is too...

I’ll give it a try. Thanks! Hopefully it’s a couple mb’s bigger…

What’s up guys? I’m a big fan of the original Paper Mario for the N64, and a couple months ago heard about a rom hack of the game that essentially recreates it with new content and battle mechanics from its sequel, Paper Mario The Thousand Year Door. It is called Paper Mario TTYD 64. Now I...

Okay, sorry for the long post gap but I finally had time to try and address the issue. I have wired up multiple Bluetooth modules, used multiple different wiring schemes, and yet still am getting no boot. First I tried to relocate it to the spot used on Noldendo Micros: nothing Second I tried...

Good work so far! This will be a really cool project to open source (I’m sure you’re not the first guy who’s wanted to make a 4 layer Noldendo). One piece of advice: do the U10 relocation BEFORE trimming. It allows you to limit potential problems post trimming if you run into any issues because...

I'm pretty sure that jefflongo's Wii Micro varient used a 4 layer board. it's a different size case, but might be more of what you're looking for.

Well, looks like it’s finally time. A composite video, wireless controller and sensor bar dependent, (disc-drive required question mark pls don’t hurt me Shank) portable, anyone? While you're at it, might as well use an OM6 trim and throw in a GameCube memory card port. Any takers?

Wait, so does this technically mean that it’s possible to create a working Wii trim that DOESN’T need RVLoader? Technically, all the requirements are met (Bluetooth, WiFi, U10, custom regs) unless there’s something else I’m missing…

I can’t just solder the test pads on the module to the points here? (since it’s a 6-layer board)

Hello ladies and gentlemodders! We’re back with another episode of “Why You Should Always Install RVLoader On You Wii Before You Try and Mod Anything On It! TM” So, I was hooking up my Wii to this new screen I’d been messing around with to test if it did in fact support component signal (thanks...

That worked like a charm! After wiring up BACK to the 12v line and hooking it up to the multimeter, I get instant boot! However, there’s still one problem. Like you said, it always turns on with AV 2, which unfortunately happens to be the back up camera input. I can still get a component signal...

Hey! Sorry to bother you again, but I just realized I had one more question. Is there any chance you know of a way to bypass the need for a power button so that it can turn on at the same time as the Wii? It’s circuitry is weird as it requires you to just tap the power button from the dedicated...

Thanks so much. That fact that it natively supports composite is a relief (may not be ideal for you veteran portablizers, but as someone who only has a 33.333333333333…% success rate at trimming Wii’s, I don’t mind at all as long as I can see that glorious title screen of my Paper Mario...

What’s up everyone? So I am currently in possession of an old car backup camera that I was planning on using as a screen for a portable project, but I can’t find ANY documentation about it online whatsoever. Here are a couple photos: Here’s what I know: It’s a 7-in screen It has 2 inputs (AV...

Thanks for the reply! And just wiring it up like that will bypass the VGA patch? This might sound super jank, but could I just run two wires (one composite and one GND) directly to a male to male Y video connector cable and connect that to a monitor?