Question Wii Voltage tolerance

[Varsius]

Hi,
before trimming my console, I wanted to make sure my custom regulators are working fine.
These are my readings from the four regulators (PTH08080WAH):
size of resistor used - output voltage reading from multimeter
82k - 0,995 V
33k - 1,138 V
2k - 3,194 V
330 - 4,98 V
Are these numbers good enough or could I run into problems when trying to power my trimmed board?

Appreciate your help.
Varsius

 

[jefflongo]

You should decrease the resistance if possible. The voltage will drop when the system is under load which might put them too low. A little above is better than a little below. You'd like to stay within +/- 0.05V under load.