Question Wii Voltage tolerance

Discussion in 'Wii' started by Varsius, Sep 17, 2019.

  1. Varsius .

    Joined:
    Aug 20, 2019
    Messages:
    10
    Likes Received:
    0
    Location:
    Berlin, Germany
    Hi,
    before trimming my console, I wanted to make sure my custom regulators are working fine.
    These are my readings from the four regulators (PTH08080WAH):
    size of resistor used - output voltage reading from multimeter
    82k - 0,995 V
    33k - 1,138 V
    2k - 3,194 V
    330 - 4,98 V
    Are these numbers good enough or could I run into problems when trying to power my trimmed board?

    Appreciate your help.
    Varsius
     
  2. jefflongo Broke BitBuilt Staff Member . .

    Joined:
    Dec 15, 2016
    Messages:
    777
    Likes Received:
    1,039
    Location:
    Ventura, CA
    Portables:
    1
    You should decrease the resistance if possible. The voltage will drop when the system is under load which might put them too low. A little above is better than a little below. You'd like to stay within +/- 0.05V under load.
     
    Stitches likes this.

Share This Page

Loading...