What's new

Worklog Wii SPii build!!!

Joined
Sep 11, 2021
Messages
13
Likes
12
Portables
2
PXL_20220308_230057140.MP.jpg

so after finishing a gwii I tried to find a much harder build to go further into portableizing then I found the Wii SPii, It looked amazing and so difficult to build so I started ordering some of the parts. I only have the PCB and a few prototype case pieces but I have begun my decent into the depths of hell and going smaller than a OMGWTF trim. Thank you very much to @StonedEdge for making this build open source!.
 

Gman

RTFDS
Staff member
.
.
.
.
.
Joined
Feb 25, 2016
Messages
1,442
Likes
2,904
I think like half of the chips on the pcb are out of stock and probably will be for a while..
 
Joined
Sep 11, 2021
Messages
13
Likes
12
Portables
2
I think like half of the chips on the pcb are out of stock and probably will be for a while..
Ya before I started I looked through all the parts needed and saw that, but I was gonna do the PCB assembly last after I had gotten everything else working. Im also planning on mostly doing this in the summer so I think I'll be good with them being out of stock for a while.
 

Gman

RTFDS
Staff member
.
.
.
.
.
Joined
Feb 25, 2016
Messages
1,442
Likes
2,904
Ya before I started I looked through all the parts needed and saw that, but I was gonna do the PCB assembly last after I had gotten everything else working. Im also planning on mostly doing this in the summer so I think I'll be good with them being out of stock for a while.
I hope you mean next summer O.o
1646850221441.png
 
Joined
Sep 11, 2021
Messages
13
Likes
12
Portables
2
PXL_20220313_021725190.jpg

Just got my first hot air soldering station for this project. because when I get the Wii I ordered I'm gonna need to relocate the nand chip to do the LMAO trim. If anyone has got some advice to do this successfully please share:D
 
Top