What the title says. I did the 3.3v mod on the driver you get from the 4layer store, and I hooked it up to the Wii. The Wii turns on just fine, it displays a crisp image (I've done the VGA mod) and then after a second it shuts off. But only when the LCD is connected.
The behavior goes as follows:
No Driver connected - Stays on
LCD, Driver connected to Wii - Shuts off
No LCD, Driver connected to Wii - Stays on
LCD, Driver connected to exterior power - Stays on
What is causing this? It happens with different driver boards, too.
(Is it possible the battery is running low?)
The behavior goes as follows:
No Driver connected - Stays on
LCD, Driver connected to Wii - Shuts off
No LCD, Driver connected to Wii - Stays on
LCD, Driver connected to exterior power - Stays on
What is causing this? It happens with different driver boards, too.
(Is it possible the battery is running low?)