Guide WaveBird Rotary Switch Guide

[Shank]

I'm surprised nobody has done this yet. The rotary switch on the WaveBird is a little bulky compared to the rest of the PCB. If you want to remove it, here is a guide of which data lines you short to ground to set it to what channel. Or you can just remove the switch and connect nothing to set it to CH11. This is for the receiver, but should be applicable for the controller switch as well.

 

[Air Conditioner]

Awesome work.

 

[Shank]

As a small note I'd like to add that wavebird receiver uses about .4 watts, including the LED. It sat at around 117mA @ 3.3v whenever the LED was on