So... The front is nearly finished. Put the controls in and everything fits perfectly .
I had to sand the front down quite a bit. But as a result it is now almost perfectly smooth and shiny (second picture).
I am happy with it.
Thank you guys for your help and advice for the print.
Ok guys, first thing when making a portable? Make a plan what you want it to have... If not, or if sloppy, you might forget some crucial parts in your finished case
I forgot the headphone jack... Luckily it was rather easy to drill a hole inside the bottom part... (The right one)
It turned out good, but I don't deserve it
Nonetheless, I started soldering, but the headphone jack took me some time... So I made few progress.
The shoulder buttons turned out very nice. Not too clicky, not too squishy.
I printed the X, Y and start buttons in white, so they match the shoulder buttons. (No pic though)
Enough for today. I'm beat
The screen does not light up, I'll have to investigate this issue tomorrow. I measured a voltage of 4.7v on the display board. Should be enough, what do you think?
Maybe the flat cable is just loose somewhere.
Sadly I can not work on it as much as I want atm :/