Festiva
.
- Joined
- Apr 26, 2018
- Messages
- 59
- Likes
- 23
Wasn't really sure where to post this, so hopefully this is fine.
My current issue is that I am trying to program a GC+ and whenever I connect the PICkit 3 to the PCB, MPLAB X IPE gives me this message:
I have the device selected as PIC18F25K22 and my tool selected. Under the power settings I enabled "Power Target circuit from Tool" and have tried setting the VDD to 5v and 3.3v will no luck.
I would really just like to know if this is a software issue with MPLAB or if I should try re-soldering my chip.
Thanks in advance.
My current issue is that I am trying to program a GC+ and whenever I connect the PICkit 3 to the PCB, MPLAB X IPE gives me this message:
MPLAB X has detected that the device’s low voltage configuration bit is set to OFF but the tool is set to low voltage programming and cannot program the device. To correct this:
1. Change the tool’s programming option to use High Voltage programming.
2. Change the device’s configuration bit to use low voltage (LVP=ON). Program the device using high voltage to reprogram the device’s configuration bit.
3. Change the tool’s programming option back to Low Voltage programming for subsequent programming of the device.
MPLAB X has detected that the device’s low voltage configuration bit is set to OFF but the tool is set to low voltage programming and cannot program the device. To correct this:
1. Change the tool’s programming option to use High Voltage programming.
2. Change the device’s configuration bit to use low voltage (LVP=ON). Program the device using high voltage to reprogram the device’s configuration bit.
3. Change the tool’s programming option back to Low Voltage programming for subsequent programming of the device.
1. Change the tool’s programming option to use High Voltage programming.
2. Change the device’s configuration bit to use low voltage (LVP=ON). Program the device using high voltage to reprogram the device’s configuration bit.
3. Change the tool’s programming option back to Low Voltage programming for subsequent programming of the device.
MPLAB X has detected that the device’s low voltage configuration bit is set to OFF but the tool is set to low voltage programming and cannot program the device. To correct this:
1. Change the tool’s programming option to use High Voltage programming.
2. Change the device’s configuration bit to use low voltage (LVP=ON). Program the device using high voltage to reprogram the device’s configuration bit.
3. Change the tool’s programming option back to Low Voltage programming for subsequent programming of the device.
I would really just like to know if this is a software issue with MPLAB or if I should try re-soldering my chip.
Thanks in advance.