Question pcb populating

Discussion in 'Wii' started by themasterofstuf, Jul 14, 2019 at 8:45 AM.

  1. themasterofstuf .

    Joined:
    Mar 27, 2019
    Messages:
    33
    Likes Received:
    0
    i want to make a wii portable but i dont want to spend 60$ on a hot air station that i will only be using for a couple of custom pcbs and not much else so i was wondering if anyone would be willing to populate a couple of pcbs for me

    i need a gc+, gmans power regulator, Jacksons's audio amp and ginger of oz's usb to micro usb board
     
  2. GingerOfOz no wario Staff Member . . .

    Joined:
    Dec 16, 2016
    Messages:
    826
    Likes Received:
    1,862
    Location:
    The Oregon Wildlands
    Portables:
    3
    Just so you're aware, both the GC+ and my Micro-USB adapter are meant to be assembled by hand, hot air may speed up the process a bit, but neither uses extremely hard to solder chips.
     
  3. jefflongo Broke BitBuilt Staff Member . . .

    Joined:
    Dec 15, 2016
    Messages:
    704
    Likes Received:
    934
    Location:
    Ventura, CA
    Portables:
    1
    At least for the GC+ and PMS, you'd be better off waiting until the store restocks.
     
    Stitches likes this.

Share This Page

Loading...