Solved omgwtf trim not outputting video

Joined
Jan 12, 2019
Messages
15
Likes
0
I have just begun my second attempt at a wii trim and i have followed the u10 relocation and trim outline carefully, but now after wiring composite to my screen's board i get a no signal prompt on my screen. it worked with the u10 relocated and no trim before. i include several photos of wiring and voltages below. one thing to note is that the on board voltages are less. the cpu and gpu heat up gradually from what i can tell, but the gpu hets a little faster. i tried jumping the reset to ground to get to priiloader but nothing happend.

the fourteen volts is the output from my power supply to the regs.
also note that some redings are in milivolts

thank you

IMG_20200715_233132.jpg
IMG_20200715_233232.jpg
IMG_20200715_182304.jpg
IMG_20200715_183334.jpg
IMG_20200715_183051.jpg
IMG_20200715_182327.jpg
IMG_20200715_184000.jpg
IMG_20200715_182825.jpg
IMG_20200715_183009.jpg
IMG_20200715_190323.jpg
 

Stitches

2 and a Half Dollarydoos
Staff member
.
.
Joined
Feb 5, 2017
Messages
3,773
Likes
2,981
Location
Banana Bender Land, Australia
Portables
6
Some of them solder joints look cold, I'd chuck some flux on and reflow them.
 
Joined
Jan 12, 2019
Messages
15
Likes
0
thank you so much it works now!!!!!! i will keep this in mind going forward!!
 
Top