Miceeno's Purple G-Boy

Aurelio

ᕕ( ᐛ )ᕗ
Staff member
.
.
.
.
.
.
Joined
Mar 3, 2016
Messages
2,050
Likes
2,721
Portables
2
Very nice wiring. Though, you forgot to peel off the protective plastic film from the copper plate. You should remove it to avoid overheat
 
Joined
Nov 30, 2016
Messages
140
Likes
265
Portables
6
I pealed a blue film off of both sides. Is there more? I scratched at the surface with a razor blade because I thought the same thing. I think the surface is etched where the air bubbles were.
 

Aurelio

ᕕ( ᐛ )ᕗ
Staff member
.
.
.
.
.
.
Joined
Mar 3, 2016
Messages
2,050
Likes
2,721
Portables
2
I pealed a blue film off of both sides. Is there more? I scratched at the surface with a razor blade because I thought the same thing. I think the surface is etched where the air bubbles were.
Ah nevermind then, it looked like air bubbles from the picture.
 
Joined
Nov 30, 2016
Messages
140
Likes
265
Portables
6
I appreciate it Aurelio. I'd hate to kill this over something so simple.

The guide wasn't clear on what thermal interface material is to be used. I used some Noctua NT-H1 I had lying around. Was I supposed to reuse the old thermal pads?
 
Top