Question I don't get video

Joined
Jul 22, 2019
Messages
13
Likes
13
Hello I am doing an advanced cut but I am stuck I think it starts but I do not get video something I am doing wrong, could you tell me thanks in advance
Do I have to relocate something else? I'm lost
 

Attachments

Gman

RTFDS
Staff member
.
.
.
.
.
.
Joined
Feb 25, 2016
Messages
1,309
Likes
2,675
A few critical things. The wire gauge does not look sufficient for the regulators. You need to use 22awg wire for 1.25v and ground.
 
Joined
Jul 22, 2019
Messages
13
Likes
13
Thank you very much gman I can start it but only if I hold the ps14 component with the tweezers at its 2 ends when I release it it stops I think it is a fuse. What should I do to change it? bridge it? I am afraid to continue without knowing what is happening. I will continue with the design of the case for now thanks to all guys.
 

Attachments

Joined
Jul 22, 2019
Messages
13
Likes
13
If I'm honest I don't know in the electronics store here in Spain they don't know awg measurements I think it's American measurement it's the thick white cable I'm waiting to receive awg 22 from amazon the ps2 is already starting and I get video the problem I have it in the ps14 fuse that I have to bypass so that it starts
 
Top