How to get 3.3v for your N64P

Discussion in 'Nintendo 64' started by BitBuiltBot, Jan 18, 2016.

  1. BitBuiltBot . Site Robot

    Joined:
    Jan 28, 2016
    Messages:
    46
    Likes Received:
    293
    You'll need:
    - A PTH08080 (Texas instruments)
    - A 100uF 16v or higher capacitor
    - A 1.87k resistor

    diagram.png

    Wire up to N64 like so:

    [​IMG]

    However in this day and age many people trim off that section of the board. There are alternate wiring points in a section that cannot be trimmed as seen here:

    Power In.png

    You're done.

    I'd recommend using a multimeter to check and make sure you're getting 3.3v out of the regulator before you try and power on the N64. You wouldn't want to kill the board by overfeeding the 3.3v line.
     
    Last edited by a moderator: Feb 20, 2016
    x121887x, Bevmo and Plaidx like this.

Share This Page

Loading...