Ok so I’ve been in contact with Gman about this and I wanted to see if anyone else could assist, the wiipms board is 100% working properly. However, when I connect it to the Wii motherboard, the voltage shows up but quickly shuts back off (probably because of a short somewhere). I know it may be almost impossible for y’all to help me figure out exactly where the short is. I measured the resistance in the voltage points on the Wii :
(3.3v reads 8.6 k Ohms)
(1.15v reads 45 ohms)
(1.0v reads 220 ohms).
Thank you in advance to anyone who can help.
I later found the solution: the alligator cables where not thick enough to handle the current coming from the batteries (:
(3.3v reads 8.6 k Ohms)
(1.15v reads 45 ohms)
(1.0v reads 220 ohms).
Thank you in advance to anyone who can help.
I later found the solution: the alligator cables where not thick enough to handle the current coming from the batteries (:
Last edited: