Question GC+ 2.0 first time setup questions

Joined
Nov 21, 2020
Messages
9
Likes
14
Location
united states
Portables
4
I'm looking at buying the GC+ 2.0 board and I was wondering if you could share a wire hookup guide for flashing the chip? I looked through the documentation and github but couldn't find anything about it. Also would I use an usb isp flasher to flash the board?

Sorry if these are newb questions. This is slightly out of my wheel house, but diving in is how I learn best.

Also, can I use the joycon breakout boards for sale here on the GC+ 2.0 board?
 
Joined
Nov 21, 2020
Messages
9
Likes
14
Location
united states
Portables
4
Noice! That brings up a point. Would I even need to flash it, of will it work out of the box?

After watching the homebrew video im assuming there must be a way to slap the joystick configurations into the GC+ 2.0? Ive never used homebrew before either. Lots to learn!
 

Stitches

2 and a Half Dollarydoos
Staff member
.
.
Joined
Feb 5, 2017
Messages
1,735
Likes
1,512
Location
Banana Bender Land, Australia
Portables
6
If you bought it from the BitBuilt store, it's already programmed and can be updated through the configurator homebrew
 
Top