Frahack
.
- Joined
- Dec 19, 2016
- Messages
- 38
- Likes
- 1
Hi,i had a lot of problems with two disc drives:
The first was working fine,with the xeno installed,and everithing was perfect,
But a day the xeno gc stopped working(by it's own),Like it wasn't installed,so i tried To solder in the other side of the board,directly To the IC,but i bridged some IC pins and removing that solder is likely impossible,
So here come the second disc drive,that i'm testing before installing the xeno gc,and stangely the disc spins for a while,but the laser doesn't turn on,so the disc can't ne found,the laser works for sure,it is clean,and the trimmer is set To 180 ohms,what can it be?And if u have a skill To remove the solder from an IC,please teach me...
The first was working fine,with the xeno installed,and everithing was perfect,
But a day the xeno gc stopped working(by it's own),Like it wasn't installed,so i tried To solder in the other side of the board,directly To the IC,but i bridged some IC pins and removing that solder is likely impossible,
So here come the second disc drive,that i'm testing before installing the xeno gc,and stangely the disc spins for a while,but the laser doesn't turn on,so the disc can't ne found,the laser works for sure,it is clean,and the trimmer is set To 180 ohms,what can it be?And if u have a skill To remove the solder from an IC,please teach me...