Question First Wii Portable. These parts good/compatible

[Warrior_Unit]

Hey Builders. I've been studying for about a week now and browsing parts and was questioning, these parts good and/or compatible. If there's something i'm missing, tell me, if there's a cheaper version or a better version of the item, tell me and i'll change it! Anyways, here are the parts!

Soldering Iron

• 40 Watt Weller https://www.amazon.com/gp/product/B000AS28UC/ref=ox_sc_act_title_20?smid=ATVPDKIKX0DER&psc=1

Solder

• 0.8mm Lead Solder (edited) https://www.amazon.com/gp/product/B005T8MXQ2/ref=ox_sc_act_title_1?smid=ATVPDKIKX0DER&psc=1

Wire

• 22 Gauge Wire (for heavier power lines) https://www.amazon.com/gp/product/B01MFEV8SG/ref=ox_sc_act_title_16?smid=AITZO53LNBA1K&psc=1
• 28 Gauge wire (for smaller power lines) https://www.amazon.com/gp/product/B01MG8VCZE/ref=ox_sc_act_title_15?smid=AITZO53LNBA1K&psc=1
• USB 3.0 A to A cable (for data wires) https://www.amazon.com/gp/product/B00P0E39CM/ref=ox_sc_act_title_7?smid=AKXVBT49GGF3B&psc=1

Switches and Tactile Switches

• 250pc Tactile Switches https://www.amazon.com/gp/product/B0722LBKV7/ref=ox_sc_act_title_19?smid=AYI27JSX7SHMW&psc=1
• 6-Pin Power Switch https://www.amazon.com/gp/product/B06XGQ4PY5/ref=ox_sc_act_title_1?smid=A21QX3PEKSFI3Z&psc=1

USB Storage and Port

• 128GB USB Drive https://www.amazon.com/gp/product/B017DH3O5A/ref=ox_sc_act_title_4?smid=ATVPDKIKX0DER&psc=1
• USB Port https://www.amazon.com/gp/product/B00H51E7B0/ref=ox_sc_act_title_10?smid=ATVPDKIKX0DER&psc=1

Battery Stuff

• Charging Circuit https://www.amazon.com/gp/product/B01M0CA4QF/ref=ox_sc_act_title_6?smid=A1564KB351MEZB&psc=1
• 18650 Batteries https://www.amazon.com/gp/product/B01HOWL44M/ref=ox_sc_act_title_12?smid=A25LX2IL3MS3O1&psc=1
• Charger http://www.batteryspace.com/smartcharger12afor74vli-ionpolymerrechargeablebatterypack--ullisted.aspx
• PTH08080WAH https://store.ti.com/PTH08080WAH.aspx

Controller Stuff

• GC Plus (You Know where to get that)
• 3DS Slider Replacement x2 https://www.amazon.com/gp/product/B00EHHTN3C/ref=ox_sc_act_title_15?smid=A10F2LH4RYXQAG&psc=1
• 3DS Slider Pads https://www.amazon.com/gp/product/B012NBH3JO/ref=ox_sc_act_title_13?smid=AS8XTNYEJEIF7&psc=1
• DS Lite Buttons (From an actual broken DS Lite)

Screen (Probably Going to Change since its almost outta stock)

• 5inch Screen https://www.amazon.com/gp/product/B00DZIA6F8/ref=ox_sc_act_title_7?smid=A867P1BBKCZM8&psc=1

Other

• Sandpaper https://www.amazon.com/gp/product/B0000AXT76/ref=ox_sc_act_title_3?smid=A3TX4YUK2VIRSQ&psc=1
• Paint https://www.amazon.com/gp/product/B00XG68SMM/ref=ox_sc_act_title_2?smid=ATVPDKIKX0DER&psc=1
• Electrical Tape https://www.amazon.com/gp/product/B001B19JLS/ref=ox_sc_act_title_9?smid=ATVPDKIKX0DER&psc=1
• Soldering Iron Tip https://www.amazon.com/gp/product/B0002BSP4K/ref=ox_sc_act_title_18?smid=ATVPDKIKX0DER&psc=1
• Desoldering Braid and Solder Sucker https://www.amazon.com/gp/product/B01I14V4X8/ref=ox_sc_act_title_11?smid=A2BS8NQ5JQVV6T&psc=1

As i said before, if anything is wrong or can be changed, tell me and i can change it

 

[Warrior_Unit]

Total Cost (at the moment) $344.16

 

[Stitches]

That screen you've listed is 480x272, so the picture's going to be pretty bad. I recommend a 640x480 or 800x480 one for better visuals. I have one of these and it's pretty dank. The battery protection circuit and charger don't match as well. The circuit is 14.8v, the charger is 7.4v. You need to pick one voltage and stick with it. Are you planning on trimming your Wii?

Also, take a gander at Digikey and Mouser for some of the parts you've found on amazon. It's usually cheaper, better quality, more reliable, better variety, and the parts all come together in antistatic bags.

You can also check the BOM for more commonly used parts and cases, and links to find them.