uesporto
.
- Joined
- Jun 6, 2018
- Messages
- 72
- Likes
- 23
Hi everyone.
I was testing a 60 revision board to see if it works with voltages around 18v because I was planning a medium sized portable and use stock regulators without many cuts.
In 19v the board stopped working, it stays in standby and whem i press the power button of the board or wiimote(apparently the bluetooth module is working) the green led turns on and the red led does not turn off then disarms instantly.
I've done several measurements and I haven't found open fuses or any shorts(No sign of defective parts).
I believe that the problem may be in some part of the regulators. what do you think? is it possible to repair?
Even if I can't repair it, I would like to know if there is any way to disable the stock regulators without the complete removal of the components, like removing just the coils or anything like that to install custom regs and finally install the bbloader to disable wi-fi and bluetooth(Had not yet installed).
I was testing a 60 revision board to see if it works with voltages around 18v because I was planning a medium sized portable and use stock regulators without many cuts.
In 19v the board stopped working, it stays in standby and whem i press the power button of the board or wiimote(apparently the bluetooth module is working) the green led turns on and the red led does not turn off then disarms instantly.
I've done several measurements and I haven't found open fuses or any shorts(No sign of defective parts).
I believe that the problem may be in some part of the regulators. what do you think? is it possible to repair?
Even if I can't repair it, I would like to know if there is any way to disable the stock regulators without the complete removal of the components, like removing just the coils or anything like that to install custom regs and finally install the bbloader to disable wi-fi and bluetooth(Had not yet installed).