Question Custom regulators

Discussion in 'Wii' started by Harry, Jan 25, 2018.

  1. Harry .

    Joined:
    Dec 30, 2017
    Messages:
    6
    Likes Received:
    1
    sorry again for another noob question, but does anyone know how to connect all the regulators together to the battery pack? Could someone please explain this to me? Thanks again
     
  2. jefflongo Broke BitBuilt Staff Member . .

    Joined:
    Dec 15, 2016
    Messages:
    768
    Likes Received:
    1,032
    Location:
    Ventura, CA
    Portables:
    1
    The positive output of the battery (which should come from your protection circuit as P+) should connect to your power switch, with the other end of the switch connected to the input of your regulators. The negative output of your battery, P-, should connect to the ground of your regulators.
     
    Stitches likes this.
  3. Stitches 2 and a Half Dollarydoos Staff Member . .

    Joined:
    Feb 5, 2017
    Messages:
    1,239
    Likes Received:
    1,132
    Location:
    Banana Bender Land, Australia
    Portables:
    6
    Ignore the resistor values, this diagram was made for the Gamecube. The wiring, however, is the same. You can just daisy chain the wires across the regs.
    charge and play.png
     
    BocuD likes this.
  4. Harry .

    Joined:
    Dec 30, 2017
    Messages:
    6
    Likes Received:
    1
    Thanks a lot guys
     
    Stitches likes this.

Share This Page

Loading...