- Joined
- Apr 14, 2021
- Messages
- 3
- Likes
- 3
Been working on the G-Boy Rev III following the manual and everything has been going smoothly until connecting the controller wiring. As far as I can tell, everything should be working. I've tested continuity with a multimeter and the connections seem reliable and solid. The Wii boots and loads BBLoader. However, button presses aren't translating to anything on the Wii. There was another thread on here about a month ago (thread: Controller not working) and I've followed the steps in that as well to try and troubleshoot. I tried connecting a GameCube controller port from the original Wii to the trim and still didn't get a response onscreen. I'm worried that maybe the trim was a bit too aggressive and there's also a spot where my Dremel slipped putting a nice gash in the board handily highlighted in one of the pics with a red circle.
Appreciate any help or insight as to what to try next or if I need to trim a new mobo.
Appreciate any help or insight as to what to try next or if I need to trim a new mobo.
Attachments
-
3.8 MB Views: 172
-
4.8 MB Views: 182
-
3 MB Views: 171