Hiabst
.
- Joined
- Apr 21, 2025
- Messages
- 3
- Likes
- 1
Hello everyone, I finished my Ashida build yesterday but I’m running into several problems. I’ll post photos later tonight when I get a chance.
1. U-Amp not being detected - Even though it’s connected exactly as shown in the Ashida PCB set instructions (jumper for analog volume controls, 3.3v and 1.8v, WS C and D with a twisted pair of ground and MC coming from the RVL-DD, S2 to the bluetooth module, and button to PMS).
2. L/R shoulder buttons - They don’t press well against the PCB and aren’t being properly detected when fully pressed. Is there a fix for this?
3. Left Z-button - It doesn’t sit properly in the case. Are there additional areas that need trimming, or should it fit just by cutting the pin?
Any help would be appreciated! I’ll update with photos once I can take them.
Thanks in advance!
1. U-Amp not being detected - Even though it’s connected exactly as shown in the Ashida PCB set instructions (jumper for analog volume controls, 3.3v and 1.8v, WS C and D with a twisted pair of ground and MC coming from the RVL-DD, S2 to the bluetooth module, and button to PMS).
2. L/R shoulder buttons - They don’t press well against the PCB and aren’t being properly detected when fully pressed. Is there a fix for this?
3. Left Z-button - It doesn’t sit properly in the case. Are there additional areas that need trimming, or should it fit just by cutting the pin?
Any help would be appreciated! I’ll update with photos once I can take them.
Thanks in advance!