resistor

Hi, before trimming my console, I wanted to make sure my custom regulators are working fine. These are my readings from the four regulators (PTH08080WAH): size of resistor used - output voltage reading from multimeter 82k - 0,995 V 33k -...

I've reviewed over and over again the section on custom regs, but still can't find or understand if the 2 (3.3v) , 1.15v, and 1v use the same resistors or different ones? My initial understanding on how to achieve the required "step down" was that 4 resistors (one on each regulator )were to...

So I'm curious, what does everyone do for resistor values regarding the pth08080w regulators? They require some pretty oddly specific resistance to get the needed voltage for wiis so I haven't been able to find singular resistors with the correct values. I haven't actually strung them together...