boot

  1. porc

    Worklog Wii in Gamecube

    I am working on a 6 layer trim based on Nold's Miicro. I finished the trim, tested the resistances and everything seems good to go, but when I have 5V connected to AV it won't turn on. When the 5V is disconnected (white wire shown below) it turns on, evidenced by the CPU heating up. I have tried...
  2. MrPresident

    Question Can't get to boot 6-layer board

    Hi everyone, after I broke my only 4 layer board, I decided to go forward and trim a 6 layer one. After testing that everything was working with the regulators and installing PortablizeMii, I decided to trim it. And to my surprise, it was working. But after working for 2 times, it died. The CPU...
  3. Acronell

    Question WiiKey/Wasp Boot

    I have never used a WiiKey or Wasp myself. When it comes to booting up, I know that Swiss is usually the primary OS/Firmware to use for making everything run nicely. However, are we capable of making the WiiKey/Wasp load something different as an OS/Firmware? Specifically, can we force the...
Top