Search results

Hi everyone, I’ve recently fried the BQ25895MRTWR on my RVL-PMS v1, I’ve bought a new one from AliExpress. I was wondering if it just need to be replaced and soldered in place, or I need to upload something in order to get it fixed?

Hi, I’ve recently fried my RVL-PMS by inserting the cell backwards :facepalm: I was wondering, since the component visibly fried is the U7, can I still use the 1.8V converter instead of the LDO? I’ve found on the forum were is the 1.8V converter, but I’m not into PCBs, so I don’t get were and...

Hi everyone, I’ve recently fried my PMSv1, so I ordered a PMS-lite, but I noticed the LDO is now required. I was very lucky to find my LDO with other trash components, it’s not in perfect condition so I would like to test it somehow. Do you know how to test it with a multimeter?

Hi, I’m building my first Wii and I thought that if the CR2032 (to power on the MX chip), runs out of battery, I have to open the case to replace the old CR2032 with a new one… To avoid those annoying operations I thought to use directly the 18650 cells (considering the negligible amount of...

Hi, I'm planning to place Wi-Fi module near the bluetooth one, and i was wondering if the short distance between the modules could cause interference somehow. Could it be?

Hello BitBuilt!!! This is my fist project, the DWii, it will have: -7” TFT display (wired with VGA) -Bluetooth -Wi-Fi -MX chip -PMSv2-lite -USB-C PD PCB -U-AMP -GC+ 2.0 -2x LRA vibration motors 2V -4x INR18650-35E 3500mAh 10A 1-35W I had troubles with my first trim, so I asked for help in the...

Hi everyone, I’m testing the trim of my Wii and it won’t boot, I double checked almost everything. The CPU and the GPU heat up when I turn the system on, also the fan starts spinning, so I guess my USB-C and my PMS are fine, I also see the files in the USB drive when I plug it in my laptop. I...

Hi, I have a 5” 800x480 TFT screen and I would like to use it in my project for a Wii portable, I’m looking for a small driver board. I found this, but I guess it’s only for arduino... I found also this one, but I don’t think it can work. Tell if I am wrong. Do you know any small driver board...

Sorry for the dumb question... Do you guys think that this screen can work with the RVL DD? It’s written that is an TFT LCD 5” 800x480 I will not use the touch panel

Hi everyone, is there any worklog or guide that explains how to relocate wifi?

Hi, I’m am going to build my first Wii portable but I can’t find some parts: -USB C PD PCB -RVL Power Management System -RVL LCD Direct Drive Those parts are currently unavailable on the store, and I don’t know when there will be a restock If anybody have those, answer me