Search results

I don't believe so. I was sitting down to re-do the layout of the 64amp this week and noticed there are not any small suitable replacements. I found another audio amp that will do the job and I am redesigning the 64AMP now.

Great job! The N64 is making a come back

Yes it is for the main IC on the controller. And yes it is intended to be salvaged from the controller.

PCB: https://github.com/Gmanmodz/N64-Controller-Module Joystick Converter MCU: https://github.com/Gmanmodz/N64-Joystick-Converter For Joystick Calibration: The joystick will not function properly until it has been calibrated. Hold Z+R while powering on to enter calibration mode. Release Z+R...

I am not positive but when there is a failure it is almost always the BQ IC that has died.

Always love a portable with a good Screen:Enclosure size ratio. Well done!

The input voltage current is not the battery current. With 15v .27A, the battery current would be around 2-3 A. So it's working as intended.

It's better if you list a recommended price when you sell something. Also these pictures are quite bad. Overall the listing is very poorly low effort. No additional features listed like what is even the internal storage size?

It should have the latest firmware in that case.

You need to wire SCW and SDW on the pms to the wii to enable the configurable features in rvloader. Make sure you are updated to the latest pms firmware as I'm not sure when you ordered this but there was an update on the fan control last year.

L4 : https://www.digikey.com/en/products/detail/samsung-electro-mechanics/CIGT201610EH2R2MNE/7041223 U8 : https://www.digikey.com/en/products/detail/texas-instruments/BQ24292IRGET/4146960

These pads were deleted from the current PMS2 and PMSLite because they were only for supporting the older STUSB4500 IC which hasn't been used for quite some time. It is fine if you leave the SD and SC wires on the usb-c board disconnected.

Looks great!

That was a small sample the fab had sent me to confirm before they built the rest of them. It will be back again soon!

well said! Update for y'all. I got an email from the fab today they sent a picture of the GC+ samples assembled. They look great and they are shipping them to me now. Then after they arrive, I'll test them, and then they will begin assembling the rest of the batch. No word on the PMS-PD yet...

Did you change the settings in RVLoader to addressable LED?

It's advised to test things as you go, and not just test if it works after everything is wired. When you test after soldering each wire, it makes it easier to troubleshoot when it is not working, because it will usually be the last wire you had soldered.

If you havent trimmed deeply into the motherboard, it's possible the traces for these signals were not cut. Give it a try if you want. It wont damage anything if you turn it on with it missing a wire, it just wont turn on.

Please provide pictures of the wiring. and also the RVLoader LED settings.

The PMS2-Lite is larger. The PMS2 has not changed in size.