Search results

Oi Doom, thanks for making me do this, and I'm going to call it finished now. Ended up with mono speaker only, and a new 800x480p screen. The battery on the back made the slot cover tight, and when I pressed it, a cartslot wire came undone. The cover is just hot glued on, and you can see the...

y-you too SS, Shank already got them. I chose a bad time to restart this, in the middle of exam week. Good thing is the audio is fixed. Don't know exactly what was causing the problems with the old amps. But shielded wire and one of the PAM8403 amps with the big potentiometer give decent...

The cover is from a food box. It's not completely flush around the cartridge, but it prevents insertion in the wrong way. Here's a pic I found of what they usually look like; http://tappakilon.com/wp-content/uploads/2016/06/img_4274.jpg fibbef; I have a few backup screens , will see if any of...

I started this portable in August 2013, for another community competition Hailrazer organized. It stared in a Wii U hardcase, but later moved into the router case it has today. Most image links in the original thread have been broken, but the photobucket album is here...

Shiiet, thats small. Maybe use a Sony memory stick for storage for the extra psp feel. There's adapters for micro SD card to memory stick so I think they are interchangable.

Doesn't micro on nffgames make pcbs that fit in the replacements sticks, or are made to be directly fit into the n64 controller?

I used this in my N64 in wii mod. http://www.edn.com/design/power-management/4427218/Latching-power-switch-uses-momentary-pushbutton

Does it need to be working? :P I have nonfunctional boards and loose ports, PM me if interested.

If you need any specific parts, I might have, and I'm closer (Sweden).

see ya next page!

wont be able to post twice then

I checked with my multimeter and I got a reading of closer to 1Mohm, so I think I overheated them when soldering. So I removed the resistor arrays and cut out the connector from a CPU-01, which has the resistor by the connector. Then I soldered it to the vias, and it worked :)... for a while at...

Shortening the power wire made no difference, all data wires are 4cm. When I short them I'll go with the connector route. The wifi didn't work when in the original connector (with verified working wifi modules) after I removed wires from resistor in my second attempt. Could I have fried some...

I'm trying to do the trim but got stuck on the first step, the wifi relocation. Butchered the first wifi module by ripping off some contact points, second also ripped a point but I was able to solder to a via instead. Then when I connected it and it didn't work, so I tried shortening a wire and...

People say that the wii component video out is inferior to the gamecubes, haven't seen it myself as I don't have gc component cable. Here's a comparison pic + info. http://retrorgb.com/gamecubevswii.html Since the component video is encoded in the AVE-RVL bypassing it and using a gcvideo could...

The gamecube apparently has better component video out than the wii, a gcvideo should solve this right?

fuck me, im stupid. The actual component is orange, so I thought it was colored orange for 5v.

Super sexy Edit: the 5v is labeled 3.3v in the first voltage picture

That's great, I have a few PTH08080 regs :) I think I got was from Loctronics notes, but that could have been for a CPU-01

Awesome work Gman!