Search results

I've completed step 13 of the guide and checked continuity between the signal and ground for composite, as well as, D+ and D- on USB. I did use the alternate points on the Wii board for USB (closer to edge of trim) and made sure both data lines were in their respective locations. Also, all...

On Step 7 of the G-Boy guide I noticed SDA, SDL, and VSys appear to have been moved to the left side of the PMS board revision I received. I don't want to apply any power to the system until I can get verification though. In the photo, my SCL, SDA, and VSys are the blue, green, and yellow...

Anyone tried? Pros: I would imagine straighter cuts if done with a guide and a flush trim bit, and maybe cleaner edges for less sanding. Cons: More debris and additional component removal. Edit: Just realized that trying to keep the mobo flush against the workbench for tracing may be too difficult.

Anyone happen to know where I can find a list of all the proper cap voltages?