Search results

Heya! Does anyone know of - or have - a reference for the ZIF connector traces on a ps2 slim? Accidentally broke off the connector, but still needed it for testing my current project. Alternatively, if you have points on where I could bodge something in elsewhere on the board and just use a...

Trying to use an ED64plus (not Krikzz everdrive, this is the chinese bootleg on amazon or ebay for $60). Works fine on my untouched N64 system. On my portable system, I removed the reset button, trimmed the board, and now this cart doesn't work. Normal carts work fine on the portable, it's...

Hello again! I seem to have a short on the 5v rail, but can't isolate it. Board looks fine and normal in that area, but every non-ground point in that 5v area around the regulator (and the 5v AV out area & NUC) now connects to ground. 12v into the regulator works, nothing's coming out of it...

I'm building a docking solution for my N64p. I have a micro USB adapter for charging on the go (wired through a 5v in to 7.4v out charger, then into the battery), and am fine-tuning a cutover to the N64 wall wart while at home (already finished the bulk of it). The wall wart will NOT be used...

Soldered in an expansion pak only to have an N64 that normally powered on fail. Spent an hour yesterday desoldering, cleaning it all up, and tracing the grounds so i'd have a better idea of where the fault could be. re-soldered last night, failed to boot again. Followed my guide to figure out...

Working my way through my first 64p. Only other portable i've done are a ton of GBA Macros (and Macro XL's). I'll ask a question I've yet to see asked or answered: Can the 2MB RAM chips (RDRAM18) be stacked? As a case scenario, removing two 2MB chips from one system, then soldering these...