Search results

i also have an eyoyo，i want use its ypbpr to connect wii，the hdmi and vga is good ，but ypbpr is strange and not clear，i think it is the problem of sharpness，but no place to change it ？？？

it‘s semi-bricked due to installing wrong region menu file， reinstall right region menu file can solve the problem

i can not wait to see the result

I hope you will win the first place

what a huge project， but you forgot one thing you live in China, so many factories can make PCB in very cheap price. all the complicated wiring makes headache

I also took almost 2 year to imitate gboy but all failed, like most of people i was happy to see the release, thanks gman! the only thing i expect now is solidworks file that can be edited, stl is not perfect to use.

Resistance 3.3V TO GND is too low， it should be 4-8 k ohms

More sanding, if still not boot, it is probably already fried. Do not power on trimmed wii when resistance is not ok.

22awg is enough for grounding，but try to add one more ground cable， maybe it works，3.3v and ground should be 8k ohm，not 8 ohm

use thicker wire for pms battery ground and voltage output ground，when battery voltage input not stable，the led will shut off

Resistance between 3.3v and ground should be around 6-8k,if less than 1k, it means somewhere short or board fried

Try to relocate MX chip and BT

Thanks for your generous sharing, can not imagine what a huge effort you have made into this project!

the scratch on back of board may lead to short somewhere

1v 6ohms is normal reading for 6 layer wii，sorry for bumping old thread

Sand more to eliminate any short of 3.3v， from my opinion， this board was most probably aready fried

two joysticks should be together connected to GC+ to function them properly

Incredible ！ Aurelio always give us big surprise

This is same thing i am working on

check the resistor array on the wii board， if it shows not 10k， Try add 10k resistor between data and 3.3v，sorry for bump old thread