Search results

Kind of new to portablizing, but would like to start working on designing a portable while I’m working on building my ashida

Do i need to place captain tape anywhere if i use the wires? I dont believe i should, but i just want to be 100% sure

Thanks! I got the Hakko for Christmas so hopefully ill be able to finish this project up soon

I was looking for some tips for my iron and wondered if you guys had any suggestions to which would be best to have for this build. I posted a link to the one i got earlier in this thread. Its the pinecil one

Yes there is but im wanting to put it into gameboy case

I’m planning on taking the ds lite gameboy advance reader and making a gameboy micro type handheld. But a little larger. Not quite sure about any more details yet.

ok thanks. Best batteries for this?

This is gonna be my concept for the WiiSki a portable wii that basically just a screen. I’m planning on doing bluetooth relocation so it can connect wii remotes. Unlike other portable wiis, the WiiSki wont have any controls on it, instead i will relocate the gamecube ports. I am also planning on...

Yea i just meant will it still run. But thanks

I accidentally enabled vga but im not doing vga output. Will this have any effect on the performance.

Finally got around to ordering everything but the stuff from 4 layer. Cant wait for it to come in

Yep and yep

Oh ok thank you

Now a new problem i think 1v may be shorted heres what i got for it: Gnd to 1v: 104.5 ohms 1v to 1.15v: 121.1 ohms 1v to 1.8v: 124.1 ohms 1v to 3.3v: 15.75k ohms

Finished trimming my wii. Was not as clean as my og wii. Any tips for practicing to solder to u10

650 degrees Fahrenheit. Also screwed up my first wii because i was being stupid and decided i was skilled enough to just solder to the u10 via without practice and then this happened will update after i trim my backup wii later.

Hows my solder job. Im not sure if its super good but it looks ok

Thanks so much.

Quick question. I know Ive probably already asked this but i just wanna be completely sure. So for wiring the wii up to the pms lite I would use my 26 awg to attach the 1v, GND, 3.3v etc. and i would use 34 awg magnet wire to hook up U10, scw, and scd

I have a question for y'all. Should I individually solder the data lines for the ashida pcb set or should i get the ribbon connector? I would like to make this as easy as possible as I am pretty new to this kind of stuff.