Search results

I have been doing research into adding Bluetooth audio for my headphones into my portable and I was wondering if anyone has done anything like it. I have been testing the A2DP example sketches for the Esp32 which is basically a Bluetooth audio transmitter. The ADC on the esp32 is not well...

I finally just invested in a 3d printer and I am starting to design my ps2 portable. I was wondering what tact switches people used for their portables that are inexpensive. I also was wondering if the ps vita's analog sticks could easily be rewired to a PlayStation 2 controller or if that...

Hey @leonardo, you need to make a new thread to ask a question. You can ask your questions there instead of using this older thread. You may want to read the rules briefly just to understand how the forum works.

I might take a look at that code as they are both written in C. I'm going to have to put a lot of work into it and a lot of online research.

I've been looking into incorporating a Teensy within my PlayStation 2 project as it would allow me to incorporate many features. The most important feature would be the ability to use it as a controller. I am aware of PS+ but I also wanted to use this microcontroller because with the raspberry...

Thanks I just bought a spool from Hatchbox, thanks for the recommendation. Thank you all for the help its been extremely useful!

Thanks @Gabobo, Il might have to buy that it looks like a major upgrade. Also just a quick question, what sort of filament do most people use for their portables, and where is the best place to buy it from?

Thank you all for the help I just bought an Ender 3 and I'm excited to finally get griding on these portables!

Thank you all so much for the help, I don't know too much about printing but is it viable to get something like an ender 3 and print off pieces instead of a full piece. I'm not sure how much money I can really spend on it so I'm wondering if buying a cheaper one would be the best option and...

I have worked on and almost finished probably 5 portables over a few years but I have barely put one(deadass built it out of glued together legos lmao) together as I can never figure out the case. I'm looking for a cheaper 3d printer that I can afford but I don't know how big a print bed I...

Damn...

This is actually very helpful. I found this years ago but I completely forgot about this so thank you so much.

I currently am working on improving my PlayStation 2 portable and I would like to be able to use a microcontroller instead of using a ps2 controller. I have a teensy 3.2 that I was hoping to use instead. Is there was any way to program this microcontroller to output what is needed to make a...

I have been working on a PlayStation 2 portable and I have limited knowledge in using li-ion batteries but I understand the danger in using them. I just bought a bms which is below that I believe will do the job well but the problem is that my batteries are not strong enough to run the ps2 and...

Modio I have been having issues with finding the correct battery and charger and bms. The batteries I have access to rn I need to have 4 batteries 2 sets of parallel and then into a series connection so that I have 7.4v to power the ps2. I would like to use this...

Modio I see you have asked in a few forums about the batteries and charging them and I have a very similar issue. Did this board you bought end up working for you?