Search results

Thanks Benge! I used PETG to print it. After that, I applied epoxy resin over the whole surface. To remove imperfections and bubbles, I applied sandpaper number 240 -> 500 -> 600 -> 1000 -> 1500 -> 2000 -> 2500 and finally, Autopolish to get a very glossy surface.

Sorry for the long delay! .. the problem I had was related with the length of the power cables for the memory card and joystick. I replaced it for short cables and everything worked fine. Thanks!

Really thanks!!!!!!!!!!!

it was a long time since my last post! so, no posts but I continued working a lot on my APS2 and finally that work finished! For now, I just wanted to share with all of you the "final product":XD: But I will try to update my post with the most important things between my last post and today...

Hi all! I know it's recommended to use a linear regulator for this voltage source because of "ps2 stability". But, what does it means? I mean, Now I'm having problems with joystick, It already worked fine, but some days ago it started to connect and disconnect, I checked all the possible reasons...

One thing I forgot to mention... Thanks @eze_manou for all the materials that you gave me!!!

Here again! a lot of things!!! Joystick PCB Working The PCB arrived after a few days and everything seems to work properly. I soldered all the components and I tested the right side(the brain). There are still some little things that I not tested but I hope everything is ok! Power sources...

Thank you!!! Yes at all!! once I have the joystick working on my APS2, I'll share the code here! Now, it's a little bit disordered :facepalm:

It was a long time after my last update. A made a lot of things in these week but I'll make the history short :XD: Related to the Joystick I finally implemented the APS2 joystick using a STM32 bluepill board because the arduino board is too slow. I bought a logic analizer and after a lot of...

Sorry, I could read that you used fusion3D... Sorry again ;-)

Hi @Benge !! Have a question :rothink:! Did you use Fusion3D to model your BPS2 ??

Oh I see!!! You know what? Yesterday was the first time that I tested the PS2toHDMI with a 5'' HDMI screen... and yessss.. There are black borders there!! And I though the same thing as you: It's a shame :( I'll upload a picture of that in my next post ;)

Hi MRKane.. sorry what is an image upscaler?

Thanks djsedaw!!... let's see what happens with that! :-)

Thanks Eze!

Hi guys.. here again! after some days, I could test joystick, USB, memory and PS2toHDMI. I tested it with Dragon Ball Budokai Tenkaichi 3 and it runs ok!! I put temporal connectors for joystick and memory to be able to disconnect it during this process. I'm using the ps2 usb board just for now...

Ok guys, I'm here again. I had to start again with a new mainboard. This time, I use a very similar version: the GH-061-12. I did all the trimming work again and after that it works. Here some photos: <OFFTOPIC> I added to my microscope a little reed switch to trigger the photo using a...

hahahha yeah I see.. ok, so thanks, I'll look into that in order to decide what to do.

Hi guys, I have some updates !! Finally, one of my best friends (Thanks Eze Manoukian) and Me trimmed the mainboard and this is the results of that: After some sanding with sandpaper of 80,500 and 600 and cleaning I got the next result: I ensured that there is no short circuit between...

Hi Benge!! question :D did you use the YPbPr output of your mainboard? I mean, are u using some ps2tohdmi or something like that? or you are using the RGB output? Thanks in advance!