Search results

Alllright. I cut the pre-amp off just for safety because I did nick it a bit when I trimmed. Still no luck. Posting my resistences. They look mostly good, but the 1.15v is a little low. My voltages are 0.96v, 1.16v, 1.77v and 3.3v respectively. The U10 pad on the PMS is also outputting 3.3v...

This is my second attempt at an Ashida. My last trim worked at first, but this one not so much. I’m using U10 emulation with the PMS-lite and my voltage line resistances are good. The CPU heats up when the board is powered on. I cut too close to the audio pre-amp area, but I don’t believe that...

Tragic update… I completely unwired my trim from the ashida and wired to PMS to test with nothing else connected and it no longer boots, just black screen. I must’ve broken something in the process of wiring up everything. I checked my resistances against the one’s on Nold’s resistance thread...

Okay... So. Composite is not working either, I'm thinking the Wii trim isn't even booting which is tragic because it definitely did before! A couple more questions in that case. When I was testing I used B+ and B- but I wired it into the Ashida as B+ and GND, that wouldn't be an issue with the...

Thanks, I was super wrong about the mode via, but I’ve moved it to TP47 now, but still no difference. And that makes a lot of sense about the power button, I just assumed it would latch. Okay I’ll switch the USB format to FAT32 right now! I really appreciate all the help! I’ll update again...

Right I forgot about that. It might be a problem. So it's a bit jank, but I read a post that said Hsync pad on the AVE isn't connected to anything, so I bent the Hsync pin off the pad and used both pads for my Vsync wire because I was having a real hard time with the soldering. Despite looking...

Thanks, I just did but unfortunately no change. A few other things to add. I had a hard time soldering to the mode via, so I moved the mode wire to this via which I believe is the same, but might not be... I did the U10 relocation myself, not using the PMS board, but again it booted before so...

Accidentally posted before adding photos. Thanks in advance for any advice !

I just finished putting together my first Ashida to find that it doesn't work. When I turn it with one battery inside on the screen turns blue and says VGA for a second, then it turns black and nothing happens. I heard some small crackling sounds, almost like something is sparking so I'm pretty...

Hello everyone