I have all the necessary lines after changing this resistor. It is also a Battery management system for 1SxP. In example, I will put 2 batteries in parallel in my device.
There is a RGB led too and a thermal probe to stop the system in case of overheating.
I edited my other theme to add those improvement, but here is the raw main theme allowing for number of rows selection from 1 to 2, along with easier access to choose the color of the selection rectangle.
These values can be changed in the gamesview.lua in the script folder.
with the newer version of RVLoader, if you just need to change the background, you can add a png, ideally 640*480 if your screen is 4/3 and 800*480 if you got the wider screen. To the background folder in RVLoader.
If you want to change the other images, you can go in the theme/asset...
I made a theme for myself, because I wanted to show game covers bigger and in one line.
It had to fit with my portable design too.
I figured out I could share it if it may interest people.
It is only 16/9. I used this as a background.
EDIT: I added a version of the theme suffixed -...
for the LDOs I connected the output of the 3v3 to their input pins and gnd to gnd, to use the on/off function.
For the 1.25V I looked in the regulator's datasheet and calculated a new res voltage divider to get this voltage.
I got a bit tired of Wii and wanted to make a portable PS2.
So far I got most components, I just got a bit of trouble sourcing a PS2 7900.
I modified the Wii PMS with two LDOs for 1v8 and 2v5 and changed the resistor on one regulator to get 1.25v. It was a bit trickier than anticipated...
They feel pretty good honestly. The LR are just under the index and the ABXY are at their correct place too.
The C-Stick and D-pad are still in a vertical position so it is not like a real controller, but it is fine.
For the fans, I think it is kinda stupid, given I had the space for a bigger one. But I had trouble sourcing 35mm ones so I gave it a go.
It is noticeable at 3v3(5V fans), but it is quite a low pitch hum so it is fine.
This is my newest portable wii and should be the last.
The beautiful 5" 16/9 screen with RVL-DD,
Brass buttons from BoxyPixel,
SD card slot with kingston adapter,
thank you, that's those ones: https://www.aliexpress.com/item/32821266407.html?spm=a2g0s.90423184.108.40.206424c4dDJfX9Y
They are cheap and nice, however only high level.
It would be better to use them in an non portable project.
I finaly took the time to recase my project so,... there's a few pictures.
5" 4/3 screen
2x 3400mAh 18650 batteries (2-3 hours of battery life)
Wii PMS and UAmp
I wanted to try something hinged for this project. I used a DSLite hinge with the original piece...