Won't boot at all, no signal. Just tested it then same results this is the current wiring. I am using 12v through the red board so disregard the...
The lowest value i got was 70 ohms and that was for the 1.15v line
The magnet wire is the cpiled up data lines for the controller they are long and messyly glued down
Great thanks !
Hi guys, i am submitting my wii portable for a school project in 2 days and my wii has stopped working. I had my wii omgwtf trim working but had...
I have files designed on altium in the following formats,
Have been unsuccessful in trying to get them...
okay great advice thanks! I will see if i can find a switch which has larger solder points but the same function, as for the usb C i am using this...
I have bought a video switch to allow for video out via YPbPr to a wii2hdmi converter. I am also using YPbPr to connect to my Eyoyo...
yeah received my samsung and it doesnt change anything unfortunately.
Hi i am having issues with my trimmed wii.
Freezes and glitches at times on the portabilize mii splash screen.
Freezes once portabilize mii has...
I sure did!
Anyone know how to fix this error?
Also it freezes every now and then and the screen flickers at times . what can be done to get the trim working...
okay testing resistance for the following voltage points:
1v to GND: 154 ohms
1.15v to GND: 60 ohms
3.3v to GND: continuisly changing doesnt...
There is a short between the 1.15v line and GND. Also seems there is a short between the pin and the shell on my AV cable for some reason. Could...
I have done the following:
I shortened the regulator wires.
I matched my resistances spot on to the guide and was achieving voltages...
Was instructed to move my queries here as opposed to a worklog.
Have followed the trim guide and can't seem to get the wii to boot.
Okay what does short mode to 3.3 mean? And yes the green is connecting my usb to ground. okay I've just realised it should have been put in YPbPr...
Upon testing my trim I am getting no signal on my eyoyo screen (vga) .
My voltages are all within +-0.05v.
Below I've attached photos of how I've...
I'm guessing they are the little solder pads with holes through them ?
I've tried setting up the USB , tried soldering USB data lines to Cm1 but I believe I've torn away the traces can I use cm2 instead?
Separate names with a comma.