Yes i did that first but I didn’t get the 5v i get different volts but I never get over 1v is always less and once I use the multimeter the...
so i got myself another N64pms board and this time im only using the multimeter but i got the same problem, i can't have the 5v working,i lifted...
I did lift the pin on the regulator, and for the multimeter I do have one it was on my right on the table, I used it too but I’m not sure if it...
Now that I disconnected I don’t get any volts, I still get the 3.3v but nothing on the 5 ,i connected the two wires to the Nintendo board before...
I’ve just connect the 64 pms to my N64 but for some reason I can’t get 5 volts all I got is 1.3 volts from it, i get the 3.3 volts but no the 5,...
this is really nice,you make them look so easy to make :). it is possible to use the switch joysticks with the regular ps2 controller?
This look really nice
Ok, thanks man.
So I’m going for the advanced trim on this board but I have a question, I’ve already removed some of the components as you can see,I only need to...
you already asked this before more than once and had an answer please stop asking the same question again.
update! Thinking that this one was going to be really easy for me was a big mistake,It started really good but now that i almost finish it I’m...
Those buttons look amazing,I’m getting myself an anycubic photon next week and I can’t wait to start printing
[ATTACH] you need to have the reset button to turn on the ps2 and i don't see one on your pictures
Update! I finally finished printing my case i used tamiya putty instead of bondo and it looks good,I’m still going to sand it more between coats...
maybe you've been doing it the wrong way:) [ATTACH]
i think you only need one and after an hour the system automatically give you posting perms
Hi everyone! Because is my first time entering in this contest i decided to do something not to difficult,im going to make a snes portable and im...
hey gman can i still buy two?
I know they look kind of weak but they’re pretty strong,besides there won’t be nothing that made them break,the board is not touching the case...
I fixed it,I did what you told me and it works thanks man now I can continue working on the case
Separate names with a comma.