Yes the only thing you want to be jump is the power switch if the reset button is jump to ground it's just like holding down the reset button it...
Unbridge the pin that's at the rest button that's probably causing it not to boot
That usually fix the problem
It's a 28awg magnet wire:D
Do you still have the BatterySpace protection circuits?
It should look like this [ATTACH] [ATTACH]
On the back i only see 1 wire that's rewired at the bottom
Can you post a front pic of the board
Did you rewire the 2 line on the front and back that's at the bottom?
[ATTACH] here's the data pinout for the controllers
Pin 34,45 & 50 are needed for the everdrive to boot
I've try to boot it with just pin 45 wired up but it will only boot without the SD
Ebay they're rare to come by every now and then you'll find some but the price for one is around 35 to 40 plus shipping they used to be cheaper...
rustoleum clear matte finish
about 3hrs+ on a full charge
Green one is sold i still have the yellow one left if anyone is interested in it
looking for someone that could make me a converter for the joystick on the original controller
original joystick to Gc joystick i know that ebay...
I forgot to mention you'll need some Flux it will really help especially since the pins are small and a thin soldering tip because the pins are...
You're welcome I've order a few hopefully they come in soon be waiting to try it out since the release of the guide :D
Here's the guide to the joycon joystick
Separate names with a comma.