It is an emulator, if you want to go that route just use a raspberry pi or anything like that. It will be cheaper and most likely the...
I am not ready to have children
The quality difference between component/VGA and composite is massive. Definitely go for the better quality
Yes, it's 1S only.
12V is recommended because it can provide more power, since the charger ic input current is limited to 3.5A
It could be caused also by poor soldering. Try reflowing the board. What does overheat? One of the inductors or one of the regs?
It's a custom design using an fpga. I haven't released any info about it yet
gcvideo already does that and it can work on the wii as well, otherwise the best option for wii portables will be this once I release it: [MEDIA]
What are you using to power it? Try using a different power supply
We have a documentation for it. Read it.
Why did you set VINDPM to 15. 3V?
The comparator circuit can work just fine, but you don't really need the transistors
Having a backplate to hold the sliders in place is definitely a better choice. The stock screws are 1.2mm and not all printers can handle that easily
The 10k resistor goes between the analog line and ground. The button must go between the analog line and 3.3V. I can't understand from the pics...
If that large rectangular thing is for the PMS, I highly suggest you to replace if with just 4 screwposts. The board gets hot when charging and...
That's not an issue with VGA. Your USB drive is not wired up properly or plugged in. The black screen is because it's booting back to the system...
You must enable 480p from the system menu, not from settings editor gui
What resistances do you measure between each voltage line and ground? Disconnect the power supplies to perform this check
Maybe I can't see very well from the picture, but did you short 3.3V to GND?
Hit me up over discord
Separate names with a comma.